GATE 2026 Mining Engineering Question Paper with Solution PDF

GATE Questions

• 1.

  A plate of 30 mm thickness is fed through a rolling mill with two powered rolls. Each roll has a diameter of 500 mm. The plate thickness is to be reduced to 27 mm in a single pass. Assume no change in width. The process feasibility and the maximum draft (in mm) can be represented, respectively, as
  Use the coefficient of friction as 0.12

  • NOT feasible and 6.0
    
  • NOT feasible and 2.6
    
  • feasible and 3.6
    
  • feasible and 3.0
    
  View Solution

  ---

• 2.

  A truss structure is loaded as shown in the figure below. Among the options given, which member in the truss is a zero-force member?

  

  \[ {Given: } F = 1000\,{N} \]

  • \(BD\)
    
  • \(BC\)
    
  • \(BA\)
    
  • \(AD\)
  View Solution

  ---

• 3.

  Two metal parts (a cylinder and a cube) of same volume are cast under identical conditions. The diameter of the cylinder is equal to its height. The ratio of the solidification time of the cube to that of the cylinder is _______________ (rounded off to 2 decimal places).
  Assume that solidification time follows Chvorinov's rule with an exponent of 2.
  

  View Solution

  ---

• 4.

  For the differential equation given below, which one of the following options is correct? \[ \frac{\partial^2 u}{\partial x^2} + \frac{\partial^2 u}{\partial y^2} = 0, \quad 0 \leq x \leq 1, 0 \leq y \leq 1 \]

  • \( u = e^{x + y} \) is a solution for all \(x\) and \(y\)
    
  • \( u = e^{x} \sin y \) is a solution for all \(x\) and \(y\)
    
  • \( u = \sin x \sin y \) is a solution for all \(x\) and \(y\)
    
  • \( u = \cos x \cos y \) is a solution for all \(x\) and \(y\)
    
  View Solution

  ---

• 5.

  The values of a function \( f \) obtained for different values of \( x \) are shown in the table below.

  

  Using Simpson’s one-third rule, approximate the integral \[ \int_0^1 f(x) \, dx \quad \text{(rounded off to 2 decimal places)}. \]

  View Solution

  ---

• 6.

  A vibrating system has a critical damping coefficient \(C_c = 350 \, \text{N}\cdot\text{s/m}\) and an actual damping coefficient \(C = 35 \, \text{N}\cdot\text{s/m}\). The logarithmic decrement of the system is approximately:

  • 0.10
    
  • 0.31
    
  • 0.63
    
  • 3.14
  View Solution