GATE 2020 Electronics Engineering Paper

GATE Questions

• 1.

  A cantilever beam of length \(L\) is fixed at the left end (\(x=0\)). It is subjected to a concentrated downward point load \(P\) and a concentrated clockwise moment \(M = \frac{PL}{2}\) at the midpoint (\(x = L/2\)). Which of the following descriptions correctly represents the Shear Force Diagram (SFD) for the beam?

  • A rectangular block of constant positive height \(P\) from \(x=0\) to \(x=L/2\), and zero shear force from \(x=L/2\) to \(x=L\).
    
  • A rectangular block of constant positive height \(P\) from \(x=0\) to \(x=L/2\), followed by another rectangular block of height \(P/2\) from \(x=L/2\) to \(x=L\).
    
  • A triangular shape increasing linearly from \(x=0\) to \(x=L/2\).
    
  • A rectangular block from \(x=0\) to \(x=L\), unaffected by the point load.
  View Solution

  ---

• 2.

  A plate of 30 mm thickness is fed through a rolling mill with two powered rolls. Each roll has a diameter of 500 mm. The plate thickness is to be reduced to 27 mm in a single pass. Assume no change in width. The process feasibility and the maximum draft (in mm) can be represented, respectively, as
  Use the coefficient of friction as 0.12

  • NOT feasible and 6.0
    
  • NOT feasible and 2.6
    
  • feasible and 3.6
    
  • feasible and 3.0
    
  View Solution

  ---

• 3.

  A truss structure is loaded as shown in the figure below. Among the options given, which member in the truss is a zero-force member?

  

  \[ {Given: } F = 1000\,{N} \]

  • \(BD\)
    
  • \(BC\)
    
  • \(BA\)
    
  • \(AD\)
  View Solution

  ---

• 4.

  A vibrating system has a critical damping coefficient \(C_c = 350 \, \text{N}\cdot\text{s/m}\) and an actual damping coefficient \(C = 35 \, \text{N}\cdot\text{s/m}\). The logarithmic decrement of the system is approximately:

  • 0.10
    
  • 0.31
    
  • 0.63
    
  • 3.14
  View Solution

  ---

• 5.

  The state of stress at a point is shown in the figure given below. Under plane stress assumption, the normal strain along the thickness direction (\(\epsilon_{zz}\)) is _________ (rounded off to 2 decimal places).

  

  
   

  View Solution

  ---

• 6.

  The values of a function \( f \) obtained for different values of \( x \) are shown in the table below.

  

  Using Simpson’s one-third rule, approximate the integral \[ \int_0^1 f(x) \, dx \quad \text{(rounded off to 2 decimal places)}. \]

  View Solution